digital monitors

Q: Do I need to use batteries?

The parent unit is supplied with rechargeable batteries 2xAAA that should be used. DO NOT use NON-rechargeable batteries.

The baby unit does not require batteries. It is designed to run on mains electricity. If mains usage is not available, it will run on 4 x AA batteries (not supplied).

Q: How long will the Parent Unit hold it charge?

The Parent unit should remain on the docking station for 16 hours before first use. It will then hold its charge for upto 8 hours.

Q: Is there any danger to my baby from electricity in the Sensor Pad?

The sensor pad DOES NOT carry any electricity and will not affect your baby, even if the mattress becomes wet.

Q: The ticking sound is annoying. How do I switch it off?

The audible ticking sound gives reassurance that your sensor pad is correctly connected and the monitor is sensing movement. If you wish to switch off the ticking sound, refer to section in Instruction Leaflet ‘adjusting the ticking sound’.

Q: There are lots of false alarms from the sensor pad. What should I do?

Check the connections are secure and test again. If alarm triggers again, INCREASE sensitivity setting and test again.

Q: There is NO alarm being triggered after 20 seconds of no movement.

Make sure there is no vibration around the sensor pad. If not, DECREASE the sensitivity setting and test again.

Q: What should I do if the LCD shows ‘No Link?

If you lose the signal/ link an alert tone will be emitted from the parent unit every 10 seconds and this will flash until the link is restored. If this happens, move closer to the baby unit.

Q: How long does the nightlight last?

If the baby unit is run on batteries  the nightlight will fade out after 5 minutes.  If is run from the mains electricity it will remain on until switched off.